Professional ac repair services for homes and businesses in Canton and surrounding Massachusetts communities.
When your air conditioner in Canton, Massachusetts blows warm air, short cycles, or fails to start, KIC Refrigeration technicians identify the exact cause through systematic testing of the refrigerant circuit, compressor windings, capacitors, and control board. We restore reliable cooling performance with precision repairs that address the root problem, not just the symptoms.
Properties throughout Canton (pop. 25,887) face unique demands when it comes to ac repair. Massachusetts heating loads, cooling calculations, and the insulation levels and duct configurations found in Canton homes all influence the approach we take. KIC Refrigeration tailors every ac repair project to the conditions your property actually faces — no generic solutions.
Choosing the right contractor for ac repair in Canton, MA makes all the difference between efficient comfort and a system that short-cycles. KIC Refrigeration uses Manual J load calculations, installs to manufacturer specifications, and backs every project with a warranty. Call (866) 858-2961 to schedule your free assessment.
How our NATE-certified technicians deliver quality ac repair results from start to finish.
We assess your air conditioning problem — no cooling, weak airflow, strange noises, ice buildup, or short cycling — and perform a safety check on electrical connections, circuit breaker, disconnect, and thermostat wiring before beginning hands-on diagnostics.
KIC Refrigeration diagnoses AC failures in Canton, MA with precision electrical and refrigerant testing. We check capacitors within 6 percent of rated microfarads, measure contactor coil resistance, verify compressor winding resistance for shorts and opens, and test the refrigerant circuit — comparing suction pressure, discharge pressure, subcooling, and superheat to the manufacturer target values for the current outdoor ambient temperature.
Our Canton technician replaces the failed part with the correct replacement for your unit make, model, and tonnage. If the failure involves the sealed refrigerant system, we recover the charge, make the repair, pressure test with nitrogen, evacuate to below 500 microns, and weigh in the correct charge of R-410A or the specified refrigerant.
We run the system for a minimum of 15 minutes, measure the temperature split across the evaporator coil (target: 16 to 22 degrees), verify suction and discharge pressures, check condenser fan and blower motor amperage, and confirm the thermostat cycles the system off at setpoint.
Transparent answers about ac repair from our certified technicians.
AC repair in Canton typically costs $150 to $500 for common component failures including run capacitors ($150 to $250), contactors ($150 to $350), condenser fan motors ($250 to $500), and blower motors ($300 to $600). Compressor replacement is the most expensive repair at $1,500 to $3,500 depending on unit tonnage and whether the system uses R-410A or older R-22 refrigerant. Evaporator coil replacement runs $800 to $2,500 including the refrigerant recovery and recharge. KIC Refrigeration provides a detailed written estimate with itemized parts and labor costs before beginning any AC repair at your Canton property so there are no surprises on the invoice.
KIC Refrigeration repairs every major air conditioning brand installed in Canton homes and commercial properties — Carrier, Trane, Lennox, Rheem, Goodman, Daikin, York, Bryant, Amana, Ruud, Heil, and all other manufacturers. Our technicians hold EPA Section 608 Universal certification for refrigerant handling and are trained to work with R-410A, R-22, R-32, R-454B, and all other regulated refrigerants found in residential and light commercial systems. Whether your AC is a 2-ton window package unit or a 5-ton split system, a 20-year-old R-22 unit or a brand-new inverter model, KIC Refrigeration has the diagnostic capability and parts access to repair it correctly at your Canton property.
An AC that repeatedly trips the circuit breaker is a safety issue that should not be ignored or reset repeatedly. The most common causes are a shorted compressor winding drawing excessive amperage, a failing run capacitor that cannot provide the boost needed for compressor startup, a locked rotor condition from a mechanically seized compressor, a ground fault from damaged wiring or a grounded compressor motor, or an undersized breaker that cannot handle the inrush current. Each reset on a breaker weakens it over time. KIC Refrigeration performs thorough electrical diagnostics at your Canton property — including megohm resistance testing on compressor windings and amperage measurements — to identify the root cause and repair it safely.
The industry guideline is to repair if the unit is under 10 years old and the repair costs less than 50 percent of a new system. AC units over 15 years old — especially those running R-22 refrigerant — are almost always better replaced. R-22 has been phased out of production and the remaining supply costs $80 to $150 per pound, making even minor refrigerant leaks prohibitively expensive to fix. A new 16 SEER2 system uses approximately 38 percent less energy than a 10 SEER unit, and many qualify for the federal energy tax credit. KIC Refrigeration helps Canton homeowners evaluate repair versus replacement based on equipment age, repair history, refrigerant type, and projected energy savings.
Our reputation is built on certified technicians, honest pricing, and results that last.
"KIC Refrigeration replaced our old window units with a mini split system. Night and day difference in comfort and noise level. Wish we had done it sooner."
"Furnace tune-up was straightforward and the technician was friendly. Gave some tips on filter replacement schedules which was helpful."
"Had a smart thermostat installed and the tech took the time to walk me through every feature and set up the app on my phone. Really appreciated that."